Aws4 request&x amz signedheaders=host&x amz signature=d74b7395369305db1f77b90dcf969154a6bb6cc4d279202450657117df525f38

Neumann KH 805 G

Active Subwoofer with 10" bass driver

Free Tech Support

$1,949.95

Aws4 request&x amz signedheaders=host&x amz signature=1cf4d768a685acf340a9027626dbd0f77f6933b9d04967b1b95b76642e42e308

Description

Augment the power of your mixing room, project studio, or any other monitoring setup with the KH 805 Active Studio Subwoofer from Neumann, a 10" woofer that reaches all the way down to 18 Hz, boasts 160W RMS / 200W peak power-handling, and features a multitude of ways to integrate with your existing set up; fourth-order crossover points, manual acoustic controls, four different routing modes, and remoteable electronics (requires optional kit)—all of these allow for greater ease and flexibility in implementation.

In addition to providing a loud and accurate low-end, the magnetically-shielded subwoofer increases the maximum SPL of your loudspeaker set up by up to 8 dB, while simultaneously decreasing any harmonic/intermodulation distortion that might be imparted by your main monitors. You can also use the KH 805 as a daisy-chain point for other subs.

Furthermore, this unit features a bass management design compatible with 2.1 systems (the common two monitor/one subwoofer arrangement) or 0.1 systems—surround 5.1, 7.1, etc. Thus, it is suitable for music mixing and surround applications, be they musical or post-production in nature.

Flexible Electronic Design

Bypassable fourth-order 80 Hz active crossover for compatibility with consumer reproductionFour routing modes on right input connector: right-channel bass management, LFE to subwoofer up to 120 Hz, wide for multichannel systems (where bass-management is the source), and Daisy Chain for subwoofer arraysSwitchable acoustic controls: Output level, low cut, parametric equalizer, and 45° step phase controlRemoteable electronics kit for less cabling and ease of use (available separately)Built-in limiter for amplifier/driver protectionLow heat dissipation

Powerful Driver and Cabinet Design

Extends frequency response down to 18 HzLow distortion due to magnetic shield and long throw driverReduced bass compression at high SPL reproduces bass frequencies in balanced proportionAllows main speakers to play louder with lower distortionWooden cabinet sports anthracite finish and high-density rubber isolating feet

Features

Optional Remote Electronics Kit

Daisy Chain for Subwoofer Arrays

Active Crossover Points

Acoustic Control to Adapt to Environment

Maximum SPL of 110.7 dB at 3% THD

Low-Frequency Extension Down to 18 Hz

10" Magnetically Shielded Woofer

200W Peak / 160W RMS Amplification

2.0 / 0.1 Bass Management

Specs

Frequency Response−3 dB Free Field: 18 Hz to 300 Hz (±3 dB) Pass-Band Free Field: 19 Hz to 300 Hz (±2 dB)
Self-Generated Noise Level< 20 dB @ 4" (10 cm) (A-weighted) 
Total Harmonic Distortion< 0.5% (95 dB SPL) @ 3.3' (1 m): > 40 Hz
Max SPL LevelIn Half Space at 3% THD @ 3.3' (1 m): 100.7 dB (averaged between 40 and 90 Hz) With Pink Noise in Half Space at 3.3' (1 m): 112 dB (linear)  
Amplifier Output Power160 W continuous / 200 W peak
THD & Noise
Controller DesignAnalog, active
Crossover FrequencyMain Channel: 80 Hz
Crossover Slope24 dB/octave (4th order)
EqualizationLow Cut EQ: Center Frequency: 30 Hz Gain: 0 dB to -12 dB Q: 1.5 Parametric EQ: Center Frequency: 20 - 120 Hz Gain: +4 dB to -12 dB Q: 1 to 8 Bypassable: Yes
Time of Flight Adjustment Delay0 - 4.69 ms @ 80 Hz (4-step: 0°, 45°, 90°, 135°); -180° switch
Bass ManagementOptional on/off remote via standard footswitch into a 1/4" / 6.3 mm jack
Protection CircuitsPeak and Thermo limiters
Infrasonic Filter FrequencySlope: 6.5 Hz, 12 dB/octave
I/O2.0 or 0.1 / 2 + daisy chain
ImpedanceElectrically Balanced: XLR, 13 kOhms
Input Sensitivity94, 100, 108, 114 dB SPL at 3.3' (1 m) for a 0 dBu input level 
Max Input+24 dBu
Audio Signal RoutingModes: Right, LFE 120 Hz, wide, daisy chain
CMRR> 56 dB @ 15 kHz
Crosstalk @ 1 kHz
Output Level Matching±0.1 dB
Dynamic Range, THD-N119 dB (A-weighted),
Gain Control+2 dB to -12 dB
Display & IndicatorsPower On: green LED Limit/Clip: "flashing" red LED Bass Management, Active: green LED
Input Voltage220 to 240 VAC / 100 to 120 VAC (switchable)
Power Consumption (Idle)Idle: 14 W Full Output: 280 W
Cabinet FinishPainted
ColorMetallic anthracite
Baffle MaterialIncluded metal grille
DriversMagnetically shielded
Woofer Diameter10" / 265 mm
Dimensions (H x W x D)14.2 x 13.0 x 25.4" / 360 x 330 x 645 mm
Weight57.3 lb / 26.0 kg
Package Weight69.0 lb
Box Dimensions (LxWxH)29.5 x 20.0 x 19.0"

Related Products

Aws4 request&x amz signedheaders=host&x amz signature=e3a64bc0ea6b0b3be6c5fd89bee7c4c360b1cb6d861f0f6c1007727c53c4064c

ATC SCM25A (Pair)

$10,990.00

More Info
Aws4 request&x amz signedheaders=host&x amz signature=2b76c57296e3880af4f800cf9e2bf1a8fc2a71e784ae0963ed02de0f18fd394e

ATC SCM50A SL Pro (Pair)

$20,990.00

More Info